[SOLVVED] Line 6: 'Str' is not a valid operator.

[Randy Walker]

Ok, now what am I doing wrong? it says "Line 6: 'Str' is not a valid operator."

Code: Select all

#SCRT = 1
#TTRM = 2
#TTDB = 3
#PTTY = 4
Ntype.i = 2
MessageRequester("Ntype values:","Current value is: "+Str(Ntype.i)+Chr(13)+"Possible values are:"+Chr(13)+"#SCRT: " Str(#SCRT)+Chr(13)+"#TTRM: " Str(#TTRM)+Chr(13)+"#TTRM: " Str(#TTRM)+Chr(13)+"#TTDB: " Str(#TTDB)+Chr(13)+"#PTTY: " Str(#PTTY))

[moulder61]

You missed a few "+" out.

Code: Select all

MessageRequester("Ntype values:","Current value is: "+Str(Ntype.i)+Chr(13)+"Possible values are:"+Chr(13)+"#SCRT: "+Str(#SCRT)+Chr(13)+"#TTRM: "+Str(#TTRM)+Chr(13)+"#TTRM: "+Str(#TTRM)+Chr(13)+"#TTDB: "+Str(#TTDB)+Chr(13)+"#PTTY: "+Str(#PTTY))

All without a senseless Repeat Forever loop too.

Moulder.

[moulder61]

Also, I just noticed #TTRM shows up twice.

Moulder.

[Randy Walker]

Ok, AGAIN -- STUPID ME> my messagerequester line was missing + sign in front of most of the Str() values:

Code: Select all

MessageRequester("Ntype values:","Current value is: "+Str(Ntype.i)+Chr(13)+"Possible values are:"+Chr(13)+"#SCRT: "+Str(#SCRT)+Chr(13)+"#TTRM: "+Str(#TTRM)+Chr(13)+"#TTRM: "+Str(#TTRM)+Chr(13)+"#TTDB: "+Str(#TTDB)+Chr(13)+"#PTTY: "+Str(#PTTY))

That fixed it. DUHH!!!
UGH!! I waste so much time on stupidity. (headbang)

[Randy Walker]

You missed a few "+" out.
All without a senseless Repeat Forever loop too.

Moulder.

Thank you Moulder.

[Piero]

That made me feel like if you said: " Str(#)"