Purebasic 5.41 LTS Beta 3 x82 in portable mode
Windows XP SP3 32 Bit
The following bug occurs with the current Beta 3.
Place and fold two procedures like shown in the following screenshot:
Then place the caret between the two procedures and press backspace to shift up the 2nd procedure to the above procedure.
While doing this, the procedure will be unfolded (thats not the bug, but by the way: why is this necessary? It's annoyingto to fold the procedure each time after editing the source outside the procedure).
So, now we should see the code of the unfolded procedure. But instead we see only the first few lines. The remaining part is cutted off.
Now, if you fold and unfold the procedure again, it will be shown correctly.
