Splitter use in form designer

[kpeters58]

I have installed 5.31 both in 32 & 64 bit flavors on Win7 and Win10 machines.

Nowhere have I been able to deploy a splitter via the form designer.

1) I create two containers side by side in the default window, butting up against each each in the middle.

2) I anchor the left one to the left, top and bottom

3) I anchor the right one to all 4 sides

4) I click on the splitter gadget, the dialog pops up and I specify both containers and click [start drawing]

5) I run - no splitter

6) I check the form code - no splitter

What am I missing?

Thanks
K

[Zebuddi123]

Hi kpeters58 personally i would use pureform it works!!! Hopefully the form designer will have been updated in the next pb release

https://www.dropbox.com/sh/g6a4j9v95b73 ... bXgfa?dl=0 ; pureform link

Zebuddi.

Code: Select all

;
Global Window_0

Global Editor_0, Editor_1, sg

Procedure OpenWindow_0(x = 0, y = 0, width = 560, height = 370)
  Window_0 = OpenWindow(#PB_Any, x, y, width, height, "", #PB_Window_SystemMenu)
  Editor_0 = EditorGadget(#PB_Any, 0, 0, 0, 0)
  Editor_1 = EditorGadget(#PB_Any, 0, 0, 0, 0)
  SplitterGadget = SplitterGadget(#PB_Any, 0, 0, width, height, Editor_0, Editor_1,#PB_Splitter_Vertical)
EndProcedure

Procedure Window_0_Events(event)
  Select event
    Case #PB_Event_CloseWindow
      ProcedureReturn #False

    Case #PB_Event_Menu
      Select EventMenu()
      EndSelect

    Case #PB_Event_Gadget
      Select EventGadget()
      EndSelect
  EndSelect
  ProcedureReturn #True
EndProcedure

OpenWindow_0()

Repeat
  event = WaitWindowEvent()
Until Window_0_Events(event) = #False

End