Can't load project due to not being able to save the current one
Posted: Fri Feb 20, 2026 5:34 pm
Hello,
I just installed PureBasic on my new Raspberry Pi 500. I usually work on Windows.
Now, I got it to work (wasn't too hard), but I ran into a problem now. I mounted a network drive and loaded a project from there. It seems I have no write access on the network drive which is a different problem.
However, whenever I want to close the project (which always reloads on startup) the editor tells me it cannot save the project...and it stays open. So I'm not able to load a different project.
Can j manually remove the project from some configuration file (PureBasic must somehow store it somewhere)?
Could this be considered to be a bug of the editor? Or am I doing something wrong?
I just installed PureBasic on my new Raspberry Pi 500. I usually work on Windows.
Now, I got it to work (wasn't too hard), but I ran into a problem now. I mounted a network drive and loaded a project from there. It seems I have no write access on the network drive which is a different problem.
However, whenever I want to close the project (which always reloads on startup) the editor tells me it cannot save the project...and it stays open. So I'm not able to load a different project.
Can j manually remove the project from some configuration file (PureBasic must somehow store it somewhere)?
Could this be considered to be a bug of the editor? Or am I doing something wrong?