PureBasic Forums - English

Posted: **Sat Jul 12, 2003 11:17 am**

hello,
I am afraid I misunderstood something concerning windows and events.

I have a main window and sometimes I have to open a new small window
(let say a child window) above the main one.

In the main window I check for a 'repaint event' like this :

Code: Select all

EVT_WIND.l = WindowEvent()

Delay (1)

If EVT_WIND > 0
  Case #PB_EventRepaint
    beep_(100,50)

Repaint event is detected (beep) if I move a system window
above my window but not if I move my child window".

In the Child window I have :

Code: Select all

EVT_WIND.l = WaitWindowEvent()
Delay (1)

Do you see where I am wrong ???
Thks

Posted: **Sat Jul 12, 2003 11:38 am**

look in the help for EventWindowId()! You need only one WindowEvent() (and when you don't don't make things while waiting for a event, use WaitWindowEvent() or you burst your Process to 100% CPU) and the find with EventWindowID() out, which window has get this message.

GPI

Posted: **Sat Jul 12, 2003 2:49 pm**

Wel... I understand my mystake (only 1 event loop) but it worst than
I thought.

Even the following does not work : If I move a message request over
my window, NO repaint event is detected

Code: Select all

  EVT_WIND.l = WindowEvent()
  Delay (1)

  If EVT_WIND > 0
      Select EVT_WIND

         Case #PB_EventRepaint
             beep_(100,30)

         Case #PB_Event_Menu 
             select  EventMenuID()

                 Case #Help				
                     MessageRequester("Test", "test, 0)

              endselect
       endselect

Do I need an exorcist

PureBasic Forums - English

Dark side of Events !!!!

Dark side of Events !!!!

Re: Dark side of Events !!!!