PureBasic Forums - English

Hi,

I'm using PureBasic 5.42 on Windows 10, 64 bit.

When I go to "Preferences > Issues", and select TODO or FIXME, and check the option "Show in procedure browser", the setting is never memorized.
Also, the "Apply" button is always disabled. The problem persists even when no files are open in the editor.

But if I click on "Update" button (next to "the New" button below the list of Issues), then the "Apply" button becomes enabled again, and I can apply the changes and preserve them.

Is it something to do with my System (ie: I'd have to run PB with Admin Priviledges to enable these options changes), or is it a bug?
Why the need to "update" before the changes in setting cab be set? NOTE: If I don't update, even if I click on "OK" all changes are lost.

Thanks

Tristano

It actually work, you need to click on the 'Update' button. I agree it's not obvious because the update button is mis-placed, it should be below the config panel.