Page 1 of 1
5.10 How to load/save?
Posted: Sun Dec 23, 2012 10:30 am
by jesperbrannmark
In 5.10 when I make a form and then save it - the extension say "pb" instead of "pbf", I don't know if this is intention or not?
Anyhow. Once I made a form and then close PB and reopen it again, I cant find any way of getting back into designer mode. Is there a different way of loading the form I just made?
Re: 5.10 How to load/save?
Posted: Sun Dec 23, 2012 11:10 am
by luciano
I found out that you can select "save as" and then select "purebasic forms (.pbf).
But on my system (Win Xp) the extension is not automatically added so I have to add it manually.
When I open the pbf file the Form editor opens.
Re: 5.10 How to load/save?
Posted: Sun Dec 23, 2012 11:32 am
by jesperbrannmark
Hm. I was trying this on the mac, and on the mac there is no dropdown to select file extension etc. I can set it hrad to pbf but it still opens as code and I am unable to get to design view...
So there are probably some differences PC/Mac there..
Re: 5.10 How to load/save?
Posted: Sun Dec 23, 2012 11:43 am
by Polo
I might have rushed the save function, I'll look at it, in the meantime just write myfile.pbf
Re: 5.10 How to load/save?
Posted: Sun Dec 23, 2012 1:37 pm
by thinkitsimple
jesperbrannmark wrote:Hm. I was trying this on the mac, and on the mac there is no dropdown to select file extension etc. I can set it hrad to pbf but it still opens as code and I am unable to get to design view...
So there are probably some differences PC/Mac there..
Confirmed on OS X 10.8.2