PureBasic Forums - English

Posted: **Wed May 22, 2002 1:31 pm**

Restored from previous forum. Originally posted by willinyork.

Hi

I have coded a front end for a dos app, and when I compile it works fine. However when you click the buttongadget which sends the instructions to the dos app it says "Error at line 179 - Filename not found"

This is the line of code causing it:

RunProgram("c:\AIFF2VAG.exe"+loop$+raw$+rate$+Chr(13)+endian$,files$, 1)

However, I DO have a program called AIFF2VAG.exe in drive C:\

I don't understand!

Posted: **Wed May 22, 2002 1:56 pm**

Restored from previous forum. Originally posted by Pupil.

Hi

I have coded a front end for a dos app, and when I compile it works fine. However when you click the buttongadget which sends the instructions to the dos app it says "Error at line 179 - Filename not found"

This is the line of code causing it:

RunProgram("c:\AIFF2VAG.exe"+loop$+raw$+rate$+Chr(13)+endian$,files$, 1)

However, I DO have a program called AIFF2VAG.exe in drive C:\

I don't understand!

The problem is that it doesn't search for a program called "c:\AIFF2VAG.exe". You see you add this to the filename loop$+raw$+rate$+chr(13)+endian$, and whatever is in those variables is added to the filename you're trying to run. So for instance if i do like this:

Code: Select all

a$ = " a$"
b$ = " b$"
parameter$ = "iff_file.iff"
RunProgram("c:\AIFF2VAG.exe"+a$+b$, parameter$, 1)

The above program will try to run this file "c:\AIFF2VAG.exe a$ b$" with the parameter "iff_file.iff". So what you want to do is this:

Code: Select all

RunProgram("c:\AIFF2VAG.exe",loop$+raw$+rate$+Chr(13)+endian$+files$, 1)

Or something similar.

Edited by - Pupil on 22 May 2002 15:38:46

PureBasic Forums - English

filename not found? but it's right there!!!