Page 1 of 1
An Procedure can not have more than 9 parameter
Posted: Sat Nov 10, 2007 3:59 pm
by CSAUER
Thanks for the new version. But what is that:
It is limited to PowerPC (is there now a Mac Intel version available?).
This looks like a new limitation since final release.
Why? This is essential and it makes it not really cross-platform.
Posted: Sat Nov 10, 2007 4:05 pm
by Fred
True, but we have a problem with the actual PPC compiler, and we won't put a lot of time on it especially because of the Intel only Mac. It wasn't working before, but no warnings was raised, so it could lead to hard to locate bugs. For now, just remove the extra parameters (shouldn't be a general case, 10 parameters or more procedures are rare).
Posted: Sat Nov 10, 2007 4:12 pm
by CSAUER
Thanks for the immediate response and clearance.
Can we expect an Intel version in the near future? Have you solved the FASM problem for Intel Mac?
Posted: Sat Nov 10, 2007 4:37 pm
by freak
As was stated before, it will happen somewhen, but for the next 2 versions our plans are different.