I can not edit the form's code
- skinkairewalker
- Enthusiast
- Posts: 637
- Joined: Fri Dec 04, 2015 9:26 pm
I can not edit the form's code
every time I try to edit the form of code, after I saved and click on run, simply disappears ...
Re: I can not edit the form's code
Hello, and welcome to the PureBasic forum.skinkairewalker wrote:every time I try to edit the form of code, after I saved and click on run, simply disappears ...
The form code can only be edited to a minimal extent, as indicated at the beginning of the generated code:
Code: Select all
;
; This code is automatically generated by the FormDesigner.
; Manual modification is possible to adjust existing commands,
; but anything else will be dropped when the code is compiled.
; Event procedures needs to be put in another source file.
;
Texas Instruments TI-99/4A Home Computer: the first home computer with a 16bit processor, crammed into an 8bit architecture. Great hardware - Poor design - Wonderful BASIC engine. And it could talk too! Please visit my YouTube Channel